Steps for preparing a single dose of insulin

Step 2. Wipe the rubber lid of the insulin bottle with an alcohol wipe or a cotton ball dipped in alcohol. Let the alcohol dry.

Note: If you are using a bottle for the first time, remove the protective cover from the rubber lid before cleaning.

Step 3. Remove the plastic cap covering the needle on your insulin syringe.

Important: Do not touch the needle.

Step 4. Pull the plunger of the syringe back and draw air into the syringe equal to the number of units of insulin to be given.

Step 5. First, insert the needle of the syringe into the rubber lid of the insulin bottle.

Next, push the plunger of the syringe to force the air into the bottle.

Then, leave the needle in the bottle.

Note: Forcing air into the insulin bottle equalizes the pressure in the bottle when you remove the dose of insulin.

Step 6. First, turn the bottle and syringe upside down.

Next, position the tip of the needle so that it is below the surface of insulin in the bottle.

Then, pull back the plunger to fill the syringe with slightly more than the correct number of units of insulin to be given.

Step 7. First, tap the barrel of the syringe so that trapped air bubbles move into the needle area.

Next, push the air bubbles back into the bottle.

Important: Make sure you have the correct number of units of insulin in your syringe.

Finally, remove the needle from the bottle.

Now you are ready to give the shot.